Skip to content

Dome Lights

Roll bar-mounted interior lighting for cabin illumination.

Specifications

Type: KC HiLiTES Cyclone V2 Quantity: 4 pods Output: 200 lumens each (800 total) Draw: 0.5A each (2A total) Size: 2.4" diameter round Part #: 1352 (single light) Wire Gauge: 16 AWG

Mounting Bracket: KC HiLiTES Dual Cyclone Dome Light Mount (#6337)

  • ADC12 aluminum, powder coated black
  • Roll cage mount design
  • Includes hardware and switch
  • Dimensions: 5.45" W × 2.61" D × 1.54" H

Control

Controller: SwitchPros Button 4 (OUTPUT-4)

  • Manual: Button 4 press
  • Rear-seat switch via TRIGGER-1 (see below)

There are no door switches: the Jeep has none, and it runs half doors or no doors (owner, 2026-09-24).

Dome lights are interior convenience lights, not required street lighting, so they run from the SwitchPros rather than the CT4.

See SwitchPros SP-1200 for wiring and trigger configuration.

Mounting

  • 2x front roll bar (above driver/passenger seats)
  • 2x rear roll bar (above rear cargo area)

Rear Seat Switch

A rear-seat switch turns the dome lights on through the SwitchPros, independent of Button 4 (resolved 2026-09-24, ⚠️ TBD #148).

Wiring: the switch is a signal switch on the SwitchPros trigger input, not a power path:

  • Blue Sea 4160 latching push button, closing SwitchPros TRIGGER-1 to ground
  • TRIGGER-1 (set active low) turns on OUTPUT-4, which feeds all four dome pods
  • No CONSTANT tap and nothing in parallel with OUTPUT-4, so nothing backfeeds the output
  • The KC #6337 bracket's own switch is not used for this

Mounting location: ⚠️ TBD #77. Trigger setup: SwitchPros SP-1200.

Outstanding Items

TBD tracker unavailable

Could not reach the GitHub issues API at build time (network or rate limit). Set GITHUB_TOKEN to raise the limit.

Build Tasks

  • Plan wire routing from SwitchPros to roll bar mounts